12V 3A Laser etched ON-OFF OEM Replacement Push Switch with dual GREEN LED lights for
TOYOTA LandCruiser 75 Series All Models
TOYOTA LandCruiser 80 Series 1990 ~ 1997
TOYOTA LandCruiser 78 / 79 Series with Steel Dash
Prado 90 Series
Prado 95 Series
This Switch Fits Following Toyota Models ONLY:
Please check the hole size before purchase
This high quality push switch from AOB is a single throw ON-OFF switch designed to operate your 12 volt accessories. It has a face surface size of 1.67" x 0.96"(42.5 mm x 24.5 mm) and uses the original mounting hole of the vehicle.
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
AOBSWT200 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSWT200 series Illumination
When switch is turned on the top light illuminates.
The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the LED LIGHT BAR logo)
Switch Logo | LED LIGHT BAR 07 |
---|---|
Color | GREEN GREEN |
Toyota_Model | LandCruiser 75s , LandCruiser 80s 1990 - 1997, LandCruiser 78 / 79s with Steel Dash model ONLY, Hilux Pre 2005 (some models), Prado 90s, Prado 95s |