Rocker Switch 663GR Laser LED BATTERY ISOLATOR GREEN RED

Rocker Switch 663GR Laser LED BATTERY ISOLATOR GREEN RED

Rocker Switch 663B Laser LED BATTERY ISOLATOR BLUE

Rocker Switch 663B Laser LED BATTERY ISOLATOR BLUE

Rocker Switch 663G Laser LED BATTERY ISOLATOR GREEN

12 volt 20amp ON OFF LASER LED Rocker Switch BATTERY ISOLATOR
$14.20

In stock

SKU
SW663G
Customize Rocker Switch 663G Laser LED BATTERY ISOLATOR GREEN
600s LED GREEN GREEN ON-OFF   + $0.00
600s LOGO BATTERY ISOLATOR   + $0.00

* Required Fields

Your Customization
Rocker Switch 663G Laser LED BATTERY ISOLATOR GREEN
Rocker Switch 663G Laser LED BATTERY ISOLATOR GREEN

In stock

$14.20

Summary

    12V 20A / 24V 10A ON-OFF Rocker Switch

     ******New LASER ETCHED & LED SERIES******

     

    This high quality 12V/24V Rocker switch from AOB is a single throw ON - OFF switch designed to operate your accessories. It has a face surface size of 1.93'' x 1.00'' (49mm x 26mm) and uses a standard din size mounting hole of 1.5'' x 0.8''(37.5mm x 21.2mm). This is the standard size of most switch holes in modern vehicles, however it is best to check your particular hole size if unsure.

     

    • Single Pole Single Throw ON - OFF switch
    • Black hard surface rocker.
    • Laser etched Legend
    • Single upper L.E.D light.
    • Single lower L.E.D light
    • Upper light is ON when the switch is pressed UP.
    • Lower light can be wired to separate dash light circuit.
    • Waterproof rating of IP66.
    • Same size as the ARB switches.
    • Rated 12V 20A / 24V 10A
    • No rear barriers between terminals.
    • This switch uses the same light configuration as the ARB switches.
    • Wiring diagram supplied with switch.

     

    All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

    The switch is rated to 20amp at 12V and 10amp at 24V however in ALL case we recommend that you wire the accessory through a fused relay.

     

     width=
    AOBSW600 series
    Rear picture showing terminals. Wiring diagram will be supplied with switch purchase. Independent wiring circuit to connect dash lights 
     width=
     
     
    AOBSW600 series Illumination


    When switch is turned on the top light (picture 3) illuminates.

    The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

    (this is a sample image with the Zombie Lights logo) 

     
    More Information
    Switch Logo BATTERY ISOLATOR 63
    Cover Type Laser etched
    Switch Layout Vertical
    Design FOR Universal
    Color GREEN GREEN
    Write Your Own Review
    You're reviewing:Rocker Switch 663G Laser LED BATTERY ISOLATOR GREEN