Rocker Switch 6B41W Laser DEER LIGHTS LED WHITE

Rocker Switch 6B41W Laser DEER LIGHTS LED WHITE

Rocker Switch 615SB Horizontal  Laser LED ROCK LIGHTS BLUE

Rocker Switch 615SB Horizontal Laser LED ROCK LIGHTS BLUE

Rocker Switch 653BM Laser Momentary WINCH IN WINCH OUT BLUE

12 volt 20amp Momentary LASER Etched Rocker Switch WINCH IN WINCH OUT
$15.20

In stock

SKU
SW653BM
Customize Rocker Switch 653BM Laser Momentary WINCH IN WINCH OUT BLUE
600s LED BLUE MOMENTARY   + $0.00
600s LOGO WINCH IN WINCH OUT   + $0.00

* Required Fields

Your Customization
Rocker Switch 653BM Laser Momentary WINCH IN WINCH OUT BLUE
Rocker Switch 653BM Laser Momentary WINCH IN WINCH OUT BLUE

In stock

$15.20

Summary

    12V 20A / 24V 10A Momentary Rocker Switch
    ******New LASER ETCHED & LED SERIES******

    This high quality 12V/24V Rocker switch from AOB is a double pole double throw (ON) - OFF - (ON) switch designed to operate your accessories. It has a face surface size of 1.93'' x 1.00'' (49mm x 26mm) and uses a standard din size mounting hole of 1.5'' x 0.8''(37.5mm x 21.2mm). This is the standard size of most switch holes in modern vehicles, however it is best to check your particular hole size if unsure.

    • Double Pole Double Throw (ON) - OFF - (ON) switch
    • Black hard surface rocker.
    • Laser etched Legend
    • Single upper LED light.
    • Single lower LED light
    • Upper light is ON when the switch is pressed UP.
    • Lower light can be wired to separate dash light circuit.
    • Waterproof rating of IP66.
    • Same size as the ARB switches.
    • Rated 12V 20A / 24V 10A
    • No rear barriers between terminals.
    • This switch uses the same light configuration as the ARB switches.
    • Wiring diagram supplied with switch.

    All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

    The switch is rated to 20amp at 12V and 10amp at 24V however in ALL case we recommend that you wire the accessory through a fused relay.

    AOBSW600 series

    Rear picture showing terminals. Wiring diagram will be supplied with switch purchase. Independent wiring circuit to connect dash lights

    AOBSW600 series Illumination

    When switch is turned on the top light (picture 3) illuminates.

    The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

    (this is a sample image with the Zombie Lights logo)

    More Information
    Switch Logo WINCH IN WINCH OUT 53
    Cover Type Laser etched
    Switch Layout Vertical
    Design FOR Universal
    Color BLUE BLUE
    Write Your Own Review
    You're reviewing:Rocker Switch 653BM Laser Momentary WINCH IN WINCH OUT BLUE