In stock
This Switch Suits the following models ONLY:
Please check the hole size before purchase
This 12 volt push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 1.28" x 0.87" (32.5 mm x 22 mm) and uses the original mounting hole of the vehicle.
This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
AOBSW900 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSW900 series Illumination
When switch is turned on the top light (picture 1) illuminates.
The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the LED LIGHT BAR logo)
Switch Logo | LED LIGHT BAR 07 |
---|---|
Color | BLUE BLUE |
Toyota_Model | 4Runner 2010 - ON, Highlander 2008 - ON, LandCruiser 200 series 08/2015 ~ ONWARDS, RAV4 2008 - 2012, Sequoia 2008 - ON, Tacoma 2012 - ON Center, Tundra 2007 - ON, Yaris 2008 |