Rocker Switch 661R Laser LED 12 VOLT POWER RED

Availability: In stock

$14.20

Price as configured: $14.20

Quick Overview

12 volt 20amp ON OFF LASER LED Rocker Switch 12 VOLT POWER

Rocker Switch 661R Laser LED 12 VOLT POWER RED

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

600s LED RED RED ON-OFF   +$0.00
600s LOGO 12 VOLT POWER   +$0.00

* Required Fields

Price as configured: $14.20

Details

 

12 Volt 20amp ON-OFF Rocker Switch

 ******New LASER ETCHED & LED SERIES******

 

This high quality 12 volt Rocker switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt power. It has a face surface size of 0.90'' x 1.92''(49mm x 23mm) and uses a standard din size mounting hole of 0.83'' x 1.45''(36.8mm x 21mm). This is the standard size of most switch holes in modern vehicles, however it is best to check your particular hole size if unsure.

 

  • Single Pole Single Throw ON - OFF switch
  • Black hard surface rocker.
  • Laser etched 12 VOLT POWER  Legend
  • Single upper L.E.D light.
  • Single lower L.E.D light
  • Upper light is ON when the switch is pressed UP.
  • Lower light can be wired to separate dash light circuit.
  • Waterproof rating of IP66.
  • Same size as the ARB switches.
  • Rated 20A 12V..
  • No rear barriers between terminals.
  • This switch uses the same light configuration as the ARB switches.
  • Wiring diagram supplied with switch.
  • Cutout dimensions are 0.83" by 1.45"(21mm x 36.83mm)
  • Panel thickness between 1/16'' and 1/4''(1.6mm~6.3mm)

 

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is rated at 20amp's however in ALL case we recommend that you wire the accessory through a fused relay.

 

 width=
AOBSW600 series
Rear picture showing terminals. Wiring diagram will be supplied with switch purchase. Independent wiring circuit to connect dash lights 
 width=
 
 
AOBSW600 series Illumination


When switch is turned on the top light (picture 3) illuminates.

The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the Zombie Lights logo) 

 

Additional Information

Special Price No

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.